Service Manual guide

VW VR6 Turbo Kit installation manual

This manual installation of the e-book of Volkswagen VR6 Turbo Kit contain 9 pages and 528 KB file size and divided into 3 section, in the section describes about preface, part list and installation manual for your Volkswagen VR6 Turbo Kit.

1. Preface
This should be some mechanical experience is as easy to install, the kit necessary for basic installation instructions.

2. Parts list
Picture of Turbo, manifold, Wastegate, pipe inlet track, silicone hoses, spark plugs, refuelling oil line feed,
3. Installing Volkswagen VR6 Turbo Kit
a. to start, disconnect the battery first.
B. Remove air filter box and associated connector pieces
c. Remove upper intake manifold as described in Robert Bentley manual. Remove the spark plug lead and various shrouds.
d. you can now replace the injectors. Be careful, because the fuel system pressure and spray (goggles and rags are definitely recommended).
e. next is line feed the oil. Intake manifold is off, you can see directly on the top of the oil filter housing.
f. you presoak all bolts/nuts from exhaust with WD-40 or something similar.
g. install you Turbo manifold (if seals replace... shot are). Cut/install heat shield for top manifold so that does not interfere with Turbo. Install Stud manifold gasket Turbo and Turbo.
h. drain oil from the pan. Remove the bolts, engine keep Pan (there are to remove a cover before you can remove the bolts on the transmission).
i. you reinstall intake manifold, use new seals when justified. Install inlet piece silicone (turning compressor) housing to facilitate easy installation. Tighten screws on compressor housings.

get here VW VR6 Turbo Kit installation manual